How To Install A Kicker Motor Bracket

Outboard Motor Bracket Instructions (Product Manual)

Annotation: Transom mounting hardware has not been supplied due to various transom depths.

Mounting Instructions

Step 1

Measure the altitude between the tiptop of the mounting clamp to the bottom of the cavitation plate.Decrease 2" from this length.

One time yous have determined the above length, add ten.5" to this length.

OBM step 1

Footstep ii

One time you lot take adamant the above length, mark this
altitude on a stick. Choose the best mounting position on
your transom for the motor. Make certain to select a position
that will not interfere with the turning of the motor.

OBM step 2

Pace 3

Position your outboard motor bracket, with the stick taped
on, and then that the bottom of the stick is ane" above the bottom
of your boat.

OBM step 3

Footstep 4

With the outboard motor bracket positioned in the
appropriate location, mark the four mounting holes as a
template. Drill the 4 holes, making certain to concord the drill
at the advisable angle of the transom.

OBM step 4

Notes

If your transom is less than 2" thick, it is recommended that you utilise a bankroll plate to ensure maximum rigidity
Ever employ a safety cable when operating your motor
Operate the motor in the everyman possible location to achieve best performance
Always raise the motor when note in use
Always remove your motor from the bracket when trailering
Do not exceed the stated motor capacity

Lowering and Raising the Motor

Note: The springs in the outboard motor bracket are meant to counter the weight of your motor. If you lot are using a particularly light motor, more pressure may exist needed when raising and lowering the motor.

To Lower Motor: Loosen the plastic black tightening screws if needed. Grasp the motor and slowly lower it to the desired height.

To Raise Motor: Pull lever handle towards the gunkhole to disengage locking pin. Grasp motor and lift up to desired peak. Release lever handle; the locking pivot will lock the motor into identify.